SDS

S
A
FETY D
A
T
A
SHEET
According to OSHA Hazard Communication Standard, 29 CFR
1910.1200
6 / 15
800001028894
US


Version 1.2 Revision Date: 07/07/2015 Print Date: 07/08/2015
tions should be taken to avoid breathing of material.
If engineering controls do not maintain airborne concentra-
tions to a level which is adequate to protect worker health,
select respiratory protection equipment suitable for the spe-
cific conditions of use and meeting relevant legislation.
Check with respiratory protective equipment suppliers.
Where air-filtering respirators are suitable, select an appro-
priate combination of mask and filter.
Select a filter suitable for the combination of organic gases
and vapours [Type A/Type P boiling point >65°C (149°F)].
Hand protection
Remarks : Where hand contact with the product may occur the use of
gloves approved to relevant standards (e.g. Europe: EN374,
US: F739) made from the following materials may provide
suitable chemical protection. PVC, neoprene or nitrile rubber
gloves Suitability and durability of a glove is dependent on
usage, e.g. frequency and duration of contact, chemical re-
sistance of glove material, dexterity. Always seek advice from
glove suppliers. Contaminated gloves should be replaced.
Personal hygiene is a key element of effective hand care.
Gloves must only be worn on clean hands. After using
gloves, hands should be washed and dried thoroughly. Appli-
cation of a non-perfumed moisturizer is recommended.
For continuous contact we recommend gloves with break-
through time of more than 240 minutes with preference for >
480 minutes where suitable gloves can be identified. For
short-term/splash protection we recommend the same, but
recognize that suitable gloves offering this level of protection
may not be available and in this case a lower breakthrough
time maybe acceptable so long as appropriate maintenance
and replacement regimes are followed. Glove thickness is not
a good predictor of glove resistance to a chemical as it is
dependent on the exact composition of the glove material.
Glove thickness should be typically greater than 0.35 mm
depending on the glove make and model.
Eye protection : If material is handled such that it could be splashed into eyes,
protective eyewear is recommended.
Skin and body protection : Skin protection is not ordinarily required beyond standard
work clothes.
It is good practice to wear chemical resistant gloves.
Protective measures : Personal protective equipment (PPE) should meet recom-
mended national standards. Check with PPE suppliers.
Environmental exposure controls
General advice : Take appropriate measures to fulfill the requirements of rele-
vant environmental protection legislation. Avoid contamination
of the environment by following advice given in Chapter 6. If
necessary, prevent undissolved material from being dis-
charged to waste water. Waste water should be treated in a
municipal or industrial waste water treatment plant before
discharge to surface water.
Local guidelines on emission limits for volatile substances