Snow Blower User Manual

8 Section 3— ASSembly & Set-Up

2. Align the holes in the chute base with the holes in the

lower chute and secure with the previously removed hex



Installing the Chute Rotation Control (If so equipped)

To install the chute rotation control (only models so equipped)

proceed as follows:

 Remove the hex lock nut and machine screw from the

chute rotation control. See Fig. 3-5.

2. 

rod and secure with the hex lock nut and machine screw



Figure 3-4

Installing the Drift Cutters (If so equipped)

 Remove the carriage bolts and flange lock nuts from the

drift cutters.

2. Install the drift cutters and secure with the carriage bolts



Installing the Recoil Starter Handle

 Remove the eye bolt and handle knob from the manual

bag.

2. 

as shown in Fig. 3-7. Do not fully tighten the hardware until

instructed to do so.

NOTE: The opening of the eye bolt should face toward the

back of the snow thrower.

Chute Rotation Control

Hex Lock

Nut

Hex Lock

Nut

Machine Screw

Chute Control Rod

Figure 3-5

Drift Cutter

Flange Lock Nut

Carriage Bolt

Figure 3-6

Eye Bolt

Handle

Knob

Recoil Starter

Handle

Figure 3-7