[A320 OTE: This Operator's Manual overs several models. Factor features may vary by model, Not al features in this manual ve applicable tall sector modes and the actor depleted nay differentiates. NOTE: Al references in this manual to the left or it side and fragrant back of the tractor are from the operating position only. Exceptions, any, will be specified. Preparation MANUALLY MOVING THE TRACTOR 1.
[ada TR INSTALLING THE HOOD COLLAR {IF NECESSARY) These are three {3) alignment posts (a) on the hood colas {b) that tine up with corresponding alignment holes in the hods (6), See Figure 5 Figures Use these assignment plats to rappelled position the hood collar {a} the secure Rn place with the hex obis t) provided the hardware bag. Tighten the hex bolts to 102-424 nbs (15148-0). Sec Figure. Figures INSTALLING THE SNAP-ON HOOD TOPPER {IF NECESSARY) 1.
AHR 2. Withe rear tabs installed, Insert the front dabs (a) on the plenum {t} as shows i Figaro 11, T= Figure 11 NOTE: The rear tabs fit into & recessed area on the top of the hood, They slide up from under the had and anti these recessed areas, 3. Push upon the bottom of the plenum to make sure that the plenum ls securely bi place. 4.
ASSEMBLE The hardware for attaching the front buyer s shipped staffed na the bumper, 1. Remove the four hex screws (2) from the bu raper {b), 2. Post ion the bumper brackets to the inside of the actors frame and secure tn place with the four hex lane screws {See Figure 15 Figure 17 LOWER DECK DISCHARGE CHUTE DEFLECTOR LYLE Never operate the mower deck without the chute deflector installed and in the down poi Figure 15 For 45" deck models: INSTALLING THE EASTATTACH™ BRUSH GUARD 1.
AE deck models: Check the tractor deck for a shipping brace that maybe holding the chute deflector upward for shipment, the braces present, It must be removed before operating the tractor, Holding tie chute deflector fully upward, remove the shipping brace, Lower the chute deflector and discard the shipping brace, See Figure 19, figures SETTING THE DECK WHEELS NOTE: Fhe deck wheels are an not-scalp feature of the deck and aie not designed to support the weight of he cutting deck.
Pen : When attaching battery cables, always connect the SHIVER {Red) wire to terminal first, followed by the NEGATIVE {Black} wire. OTE: The positive battery seminal is marked Pos, (#1. The negative leathery Deming] is marked Neg. -) Connecting the Battery Cables Always connect the passive ead to the battery before connecting the negative lead, This will prevent sparking ar possible Injury from an electrical short caused by contacting the tractor beauty with tools belong used to connect tabla.
ASSEMBLY Remove the hex tap screw and mut securing the black negative battery lead to the negative battery post mated NEG), Move the cable away farm the negative battery post. Remove the hex cap screw and nut securing the red positive battery lair to the positive battery post (marked POSE. Carefully lift the battery owl of he tractor. Install the battery by repeating the above sips in the Reverse order.
SERVICE AND MAINTENANCE Follow the Maintenance Schedule given helot. This chart PN describes service guidelines only, Before performing any type of acquaintanceship, Refer tonic Engine Operator's Manual for engine maintenance disengage all control sand spat the engine. Quantitation | sidearms sifted in the table below, moving parts have come Tara complete stop, Allow the engine ta aol. Disconnect spark plug ive and ground It against the engine to prevent unintended starting.
