SDS

Safety Data Sheet
MTD Bar and Chain Lubricant
Revision Date:
4/30/15
SECTION 3
SECTION 4
Eye Contact:
Skin Contact:
Inhalation:
Ingestion:
Other:
Note to Physicians:
SECTION 5
Flash Point:
Flammable limits:
Extinguishing media:
Special firefighting procedures:
Unusual fire & explosion
hazards:
Byproducts of combustion:
Autoignition temperature:
Explosion data:
Other:
The balance of components do not contribute to the overall classification of the fluid, according to the GHS Standard.
Not determined.
Fires involving this product may release oxides of carbon, phosphorus, nitrogen and
sulfur; reactive hydrocarbons and irritating vapors.
Dense smoke may be generated while burning. Toxic fumes, gases or vapors may
evolve on burning. High temperatures may create heavy flammable vapors that may
settle along ground level and low spots to create an invisible fire hazard.
Dispose of fire debris and contaminated extinguishing water in accordance with official
regulations.
Use dry chemical, alcohol foam, all purpose AFFF or carbon dioxide to extinguish fire.
Get medical advice or attention if you feel unwell or are concerned.
If you feel unwell or concerned: Get medical advice/attention. Rinse mouth. Do NOT
induce vomiting. If vomiting occurs naturally, lie on your side, in the recovery position.
DO NOT direct a solid stream of water or foam into hot, burning pools of liquid since this
may cause frothing and increase fire intensity. Frothing can be violent and possibly
endanger any firefighter standing too close to the burning liquid. Use water spray to cool
fire exposed containers and structures until fire is out if it can be done with minimal risk.
Avoid spreading burning material with water used for cooling purposes. Wear full
firefighting turn-out gear (full Bunker gear), and respiratory protection (SCBA).
Not determined. Care should always be exercised in dust/mist areas.
FIRE FIGHTING MEASURES
200°C by Cleveland Open Cup Tester.
If you determine that a medical emergency exists and the specific chemical identity is
necessary for emergency or first-aid treatment we will immediately disclose the specific
Not determined.
COMPOSITION OF INGREDIENTS
FIRST AID MEASURES
No additional information
Avoid direct contact. Wear chemical protective clothing, if necessary. Take off
contaminated clothing, shoes and leather goods (e.g. watchbands, belts). Wash skin with
lukewarm, gently flowing water and mild soap until product is removed. Call a doctor if
you feel unwell. If skin irritation or rash occurs: Get medical advice/attention. Wash
contaminated clothing before re-use.
Avoid direct contact. Wear chemical protective gloves, if necessary. Remove source of
exposure or move person to fresh air. Rinse eyes cautiously with lukewarm, gently
flowing water for several minutes, while holding the eyelids open. Remove contact
lenses, if present and easy to do. Take care not to rinse contaminated water into the
unaffected eye or onto the face. If eye irritation persists: Get medical advice or attention.
Component
CAS Number Percentage (by weight)
Solvent Refined Heavy Napthenic Distillate
64741-96-4 45-75%
Page 2 of 7