Product Manual A

Fig. 3

Fig. 4

Mount Bracket

Cutting Head Shield

Slot

Tab

Bolt

Hole

Washer

Bolt

Wing Nut

CONNECTING THE UPPER AND LOWER SHAFTS

1. Set the unit on a at, level surface.

2. Turn the upper portion of the unit upside down. The holes on the coupler should face up (Fig. 5).

3. Turn the lower portion of the unit upside down. The holes on the lower shaft housing should face

up (Fig. 5).

4. Push the lower shaft housing into the coupler (Fig. 5). The holes on the lower shaft housing should

align with the holes on the coupler (Fig. 6).

IF... the lower shaft housing does not enter the coupler completely and the holes do not align, remove

the lower shaft housing, rotate the cutting head slightly (1/8th turn) and repeat step 4 (Fig. 7).

5. Insert the screws (x2) into the aligned holes (Fig. 6).

6. Tighten the screws securely with a #2 Phillips screwdriver.

WARNING: To prevent serious personal injury or damage to the unit, always make

sure that the screws are securely tightened before each use.