SDS

ManualsBrandsTroy-Bilt ManualsGas Leaf Blowers205 MPH 450 CFM 27 cc 2-Cycle Full-Crank Engine Gas Leaf Blower

Safety Data Sheet

MTD Bar and Chain Lubricant

Revision Date:

4/30/15

Prepared according to Global Harmonized System (GHS) standards

SECTION 1

Product Trade Name:

CAS Number:

Synonyms/Other:

Part Number(s):

Recommended Use:

Restrictions on Use:

Created Date:

Preparation/Revision Date:

Transportation Emergency

Phone Number:

SDS CODE:

SECTION 2

Appearance:

Odor:

Classification:

Target Organs:

Pictogram(s):

Signal Word:

Hazard Statement:

Other Hazards:

Prevention:

Response:

Storage Procedures:

Disposal:

Other:

MTD Bar and Chain Lubricant

CHEMICAL PRODUCT IDENTIFICATION

None required.

See section 11 for complete health hazard information.

WARNING

H315 - Causes skin irritation

H319 - Causes serious eye irritation

Not determined.

Red fluid.

Not determined.

Bar and chain lubricant.

Genuine Parts Bar and Chain Oil, Atlas Bar and Chain Oil, Arnold Bar and Chain Oil,

Craftsman Band and Chain Oil

Skin, Eyes

Skin corrosion / irritation category 2

Eye damage / irritation category 2

Moderate oily odor.

4/30/2015

N/A

Mixture.

1-800-424-9300 (CHEMTREC)

13314

HAZARD IDENTIFICATION

4/30/2015

P264 - Wash hands thoroughly after handling

P280 - Wear protective gloves/eye protection

P362 - Take off contaminated clothing and wash before reuse

P302+P352 - IF ON SKIN: Wash with soap and water

P304+P341 - IF INHALED: If breathing is difficult, remove victim to fresh air and keep at

rest in a position comfortable for breathing

P305+P351+P338 - IF IN EYES: Rinse cautiously with water for several minutes.

Remove contact lenses if present and easy to do – continue rinsing

P332+P313 - If skin irritation occurs: Get medical advice/attention

P337+P313 - If eye irritation persists get medical advice/attention

Lubrication Technologies, Inc.

900 Mendelssohn Avenue North

Golden Valley, MN 55427-4309

Tel: 763-545-0707

Page 1 of 7

Summary of content (13 pages)

PAGE 1
Safety Data Sheet MTD Bar and Chain Lubricant Revision Date: 4/30/15 Prepared according to Global Harmonized System (GHS) standards CHEMICAL PRODUCT IDENTIFICATION SECTION 1 Lubrication Technologies, Inc. 900 Mendelssohn Avenue North Golden Valley, MN 55427-4309 Tel: 763-545-0707 Product Trade Name: MTD Bar and Chain Lubricant CAS Number: Synonyms/Other: Mixture.
PAGE 2
Safety Data Sheet MTD Bar and Chain Lubricant Revision Date: 4/30/15 SECTION 3 COMPOSITION OF INGREDIENTS Component Solvent Refined Heavy Napthenic Distillate CAS Number 64741-96-4 Percentage (by weight) 45-75% The balance of components do not contribute to the overall classification of the fluid, according to the GHS Standard. SECTION 4 FIRST AID MEASURES Eye Contact: Avoid direct contact. Wear chemical protective gloves, if necessary. Remove source of exposure or move person to fresh air.
PAGE 3
Safety Data Sheet MTD Bar and Chain Lubricant Revision Date: 4/30/15 SECTION 6 ACCIDENTAL RELEASE MEASURES Spill control procedures (land): Immediately turn off or isolate any source of ignition (pilot lights, electrical equipment, flames, heaters, etc.). Evacuate area and ventilate. Personnel wearing proper protective equipment should contain spill immediately with inert materials (sand, earth, chemical spill pads of cotton) by forming dikes.
PAGE 4
Safety Data Sheet MTD Bar and Chain Lubricant Revision Date: 4/30/15 Local control measures: Use adequate ventilation when working with material in an enclosed area. Mechanical methods such as fume hoods or area fans may be used to reduce localized vapor/mist areas. If vapor or mist is generated when the material handled, adequate ventilation in accordance with good engineering practice must be provided to maintain concentrations below the specified exposure.
PAGE 5
Safety Data Sheet MTD Bar and Chain Lubricant Revision Date: 4/30/15 SECTION 11 TOXICOLOGICAL INFORMATION Acute toxicity (LD50) *See note at the bottom of the section >5000 mg/kg Oral: >5000 mg/kg Dermal: >20.0 mg/l Inhalation: Causes skin irritaton Skin irritation: Causes serious eye irritation Eye irritation: Not expected to have a sensitizing effect. Dermal sensitization: Not expected to have a sensitizing effect.
PAGE 6
Safety Data Sheet MTD Bar and Chain Lubricant Revision Date: 4/30/15 SECTION 14 Land Transport (DOT): Proper Shipping Name: Land Transport (TDG): Proper Shipping Name: Sea Transport (IMDG): Proper Shipping Name: Air Transport (IATA): Proper Shipping Name: Other: SECTION 15 Federal Regulation Clean water act/oil: TSCA: Other TSCA: SARA title III: CERCLA: State Regulations Right-to-know Other: TRANSPORT INFORMATION Not regulated for land transport. Not applicable. Not regulated for land transport.
PAGE 7
Safety Data Sheet MTD Bar and Chain Lubricant Revision Date: 4/30/15 OTHER INFORMATION SECTION 16 NFPA 704 1 1 0 None N/A HEALTH: FIRE: REACTIVITY: SPECIFIC HAZARD: PROTECTION INDEX: Version: NPCA-HMIS 1 1 0 N/A B KEY 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Severe I INFORMATION PROVIDED IN THIS SDS IS CONSIDERED ACCURATE AND RELIABLE BASED ON INFORMATION ISSUED FROM INTERNAL AND OUTSIDE SOURCES TO THE BEST OF THE AUTHORS' KNOWLEDGE.
PAGE 8
Safety Data Sheet MTD Synthetic 2T Revision Date: 4/29/15 Prepared according to Global Harmonized System (GHS) standards CHEMICAL PRODUCT IDENTIFICATION SECTION 1 Lubrication Technologies, Inc.
PAGE 9
Safety Data Sheet MTD Synthetic 2T Revision Date: 4/29/15 SECTION 4 Eye Contact: Skin Contact: FIRST AID MEASURES If irritation occurs, cautiously rinse eyes with lukewarm, gently flowing water for 5 minutes, while holding the eyelids open. If eye irritation persists: Get medical advice/attention. Avoid direct contact. Wear chemical protective clothing, if necessary. Wash skin with lukewarm, gently flowing water and mild soap until product is removed. Call a doctor if you feel unwell.
PAGE 10
Safety Data Sheet MTD Synthetic 2T Revision Date: 4/29/15 Waste disposal method: Other: SECTION 7 Do not empty into drains. All disposals must comply with federal, state, and local regulations. The material, if spilled or discarded may be a regulated waste. Refer to state and local regulations. Department of Transportation (DOT) regulations may apply for transporting this material when spilled. See Section 14.
PAGE 11
Safety Data Sheet MTD Synthetic 2T Revision Date: 4/29/15 Consumption of food and drink should be avoided in work areas where product is present. Always wash hands and face with soap and water before eating, drinking or smoking.
PAGE 12
Safety Data Sheet MTD Synthetic 2T Revision Date: 4/29/15 Mutagenicity: Carcinogenicity: Reproductive toxicity: STOT-single exposure: STOT-repeated exposure: Other: SECTION 12 Environmental toxicity Fish: Invertebrates: Aquatic plants: Microorganism: Persistence/Degradability: Bioaccumulation: Mobility in soil: Other: SECTION 13 Waste disposal: Other SECTION 14 Land Transport (DOT): Proper Shipping Name: Land Transport (TDG): Proper Shipping Name: Sea Transport (IMDG): Proper Shipping Name: Air Transpor
PAGE 13
Safety Data Sheet MTD Synthetic 2T Revision Date: 4/29/15 REGULATORY INFORMATION SECTION 15 Federal Regulation Clean water act/oil: TSCA: Other TSCA: SARA title III: CERCLA: State Regulations Right-to-know Other: Under Section 311 of the Clean Water Act (40 CFR 110) and the Oil Pollution Control Act of 1990, this material is considered an oil. Any spill or discharges that produce a visible sheen or film on surface of water, or in waterways, ditches, or sewers leading to surface water must be reported.