Instructions / Assembly

IMPORTANT: READ THE OPERATOR’S MANUAL THOROUGHLY AND FOLLOW
THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Lea la traducción en Español en el manual.
NEED HELP? CALL 1-800-828-5500
ASSEMBLY TOOLS REQUIRED
• Scrench (provided) - for chain tensioning
DIDN’T START?
Repeat the starting
instructions.
If the unit still fails to start,
refer to the operator’s
manual for additional
starting and troubleshooting
information.
Set the unit on a flat, level
surface. Crouch in the starting
position. Hold the front handle
with the left hand. Hold the
starter rope grip with the right
hand. Insert the right foot into the
boot loop to help hold the unit
firmly in place.
Pull the starter rope with a
controlled and steady motion 5
times.
Push the choke knob in to
Position 2.
Pull the starter rope with a
controlled and steady motion 3
to 5 times to start the engine.
Allow the engine to warm up for
30 to 60 seconds.
Press and hold the throttle
lockout. Lightly squeeze and
release the throttle control to idle
the engine.
5 6
7
8 9
Read the operator’s manual
thoroughly before operating
the unit. Follow all warnings and
safety instructions. This fast
guide is intended as a reference
for users that have already read
the operator's manual and are
familiar with the necessary safety
precautions.
Reinstall the chain oil cap. Wipe
up any oil that may have spilled.
NOTE: Oil will slowly flow from
the reservoir onto the chain.
Check the chain oil level
frequently.
This unit must be checked for
proper chain tension prior to
use. Refer to the operator’s
manual for complete instructions.
Check the chain tension
frequently.
Position the unit with the fuel cap
facing up. Slowly remove the fuel
cap. Fill the fuel tank. Reinstall
the fuel cap. Move the unit at
least 30 ft. (9.1 m) from the fuel
container and the fueling site
before starting the engine.
40:1
Mix thoroughly in a separate fuel
can:
– 3.2 fl. oz. of 2-cycle engine oil
– 1 gallon of fresh unleaded
gasoline (less than 30 days old)
NOTE: Do not mix directly in the
unit fuel tank.
Set the unit on a flat, level
surface. Unscrew the chain oil
cap. Carefully pour the bar and
chain oil into the chain oil
reservoir. DO NOT overfill.
1 2
5
3 4
6
ASSEMBLY
Pull the choke knob out to
Position 1.
NOTE: DO NOT touch the
throttle control until step 9.
4
To reduce the chance of injury,
engage the chain brake until you
are ready to begin operation.
When ready, disengage the chain
brake.
Press the throttle lockout and
squeeze the throttle control to
accelerate the engine, as
needed.
10
Make sure the chain brake is
disengaged. Pull the chain brake
lever back toward the front
handle.
Move the On/Off switch to the
On ( I ) position.
1
2
STARTING
Slowly press and release the
primer bulb 10 times, or until fuel
is visible.
3
Starter Rope Grip
Fuel Cap
Throttle Control
On / Off Switch
Choke Knob
Primer Bulb
Front Handle
Chain Brake Lever /
Front Hand Guard
Chain Oil
Cap
Rear Handle / Boot Loop
Throttle
Lockout
778-19325 / 00 07/21