SDS

MTD 4-CYCLE SMALL ENGINE OIL HD SAE 30 October 10, 2018
Page 5 of 9
Standard Operating Procedure (SOP) for special handling instructions.
Body protection: No protective equipment is needed under normal use conditions. For non-routine
tasks, personal protection equipment for the body should be selected based on the
task being performed and the risks involved.
Other skin protection: Appropriate footwear and any additional skin protection measures should be
selected based on the task being performed and the risks involved.
Respiratory protection: No respiratory protection is normally required. If user operation generates an oil
mist, determine if airborne concentrations are below the occupational exposure limit
for mineral oil mist. If not, wear an approved respirator that provides adequate
protection from measured concentrations of this material. The correct choice of
respiratory protection depends upon the chemicals being handled, the conditions of
work and use, and the condition of the respiratory equipment. For air-purifying
respirators use a particulate cartridge. Use a positive pressure air-supplying
respirator in circumstances where air-purifying respirators may not provide
adequate protection.
Section 9. Physical and Chemical Properties
Attention: Data represents typical or target values and are not intended to be specifications.
Appearance
Physical State
:
Liquid
Color
:
Clear amber
Odor
:
Petroleum odor
Odor threshold
:
Not available
pH
:
Not applicable
Pour point
:
-9°C to -36ºC (15.8°F to -32.8°F ) (Typical or Target)
Boiling Point
:
Not available
Flash Point (Closed cup)
:
>176.6 °C (>350 °F) (Typical or Target)
Evaporation rate
:
<1 (Butyl acetate = 1)
Flammability (solid, gas)
:
Not applicable. Based on - Physical state
Lower and upper explosive
(flammable) limits
:
Not available
Vapor pressure
:
<0.01 mmHg Maximum @ 37.8 ºC (100 ºF)
Vapor density (Air +1)
:
>1 Minimum
Relative density
:
0.86 - 0.88 kg/l at 15°C (Typical or Target)
Solubility
:
In soluble in water
Partition coefficient: n-
Octanol/water
:
Not available
Auto-ignition temperature
:
Not available
Decomposition temperature
:
Not available
Viscosity (cSt @ 40 °C)
:
46 – 100 mm2/s (cSt) @ 40 ºC (104 ºF) (Typical or Target)
Viscosity (cSt @ 100 °C
:
5.6 – 17.1 mm2/s (cSt) @100 ºC (212 ºF) (Typical or Target)
VOC %
:
None
Section 10. Stability and Reactivity
Reactivity: Not reactive under normal storage conditions
Chemical stability: Stable under normal storage conditions
Possibility of hazardous reactions: None under normal processing.
Hazardous polymerization: Hazardous polymerization does not occur.
Conditions to avoid: Heat, flames and sparks.
Incompatible materials: Oxidizing agents, Halogens, Halogenated compounds