Operator's Manual

ManualsBrandsTroy-Bilt ManualsEdger(9") 140cc 4-Cycle Edger

Assembly & Set-Up

NOTE: This machine is shipped WITHOUT GASOLINE

or OIL. After setting up the edger, service the engine

with gasoline and oil as instructed in the Engine

Operator’s Manual.

NOTE: Reference to right or left hand side of the

edger is observed from the operating position.

Assembly

Handle

Remove and discard any packaging cardboard that

may be present between the upper handle and the

lower handle.

1. Pivot the upper handle upward until it snaps

into place. See 1 in Figure 2-1.

Figure 2-1

2. Tighten the star knobs (a), which are located

on both the left and right sides of the handle.

See 2 in Figure 2-1.

Control Cable Z-Fitting

Unwrap the control cable from the engine and route

it under the lower handle.

1. Hook the Z end of the brake cable into

the control from the outside to inside. See

Figure 2-2.

Z-Fitting

Blade Control

Upper

Handle

Figure 2-2

Securing Control Cable

WARNING: The cable must be routed

properly to avoid contact with all sharp

edges and hot surfaces. Such contacts

damage the cable and render the

controls inoperative.

1. Press the stud found inside the snap fitting

into the hole found on the left side of the

upper handle, as shown in Figure 2-3.

Upper

Handle

Stud

Snap Snap

FittingFitting

Figure 2-3

2. Push the snap fitting down on the handle to

secure it into place.

• Edger (1) • Wing Knob and Rope Guide (1) • Trenching Blade Kit † (1)

• Edger Operator’s Manual (1) • Engine Operator’s Manual (1) • Fast Start Guide † (1)

• Registration Card (1) • Parts/Warranty Supplement Sheet (1) • Oil (1)

† If Equipped

Contents of Carton

Thank you for purchasing this product. It was carefully engineered to provide

excellent performance when properly operated and maintained.

Please read this entire manual prior to operating the equipment. It instructs you

how to safely and easily set up, operate and maintain your machine. Please be

sure that you, and any other persons who will operate the machine, carefully

follow the recommended safety practices at all times. Failure to do so could

result in personal injury or property damage.

All information in this manual is relative to the most recent product information

available at the time of printing. Review this manual frequently to familiarize

yourself with the machine, its features and operation. Please be aware that

this Operator’s Manual may cover a range of product specifications for various

models. Characteristics and features discussed and/or illustrated in this manual

may not be applicable to all models. We reserve the right to change product

specifications, designs and equipment without notice and without incurring

obligation.

If applicable, the power testing information used to establish the power rating

of the engine equipped on this machine can be found at www.opei.org or the

engine manufacturer’s web site.

If you have any problems or questions concerning the machine, phone an

authorized service dealer or contact us directly. Customer Support telephone

numbers, website address and mailing address can be found on this page. We

want to ensure your complete satisfaction at all times.

Throughout this manual, all references to right and left side of the machine are

observed from the operating position.

The engine manufacturer is responsible for all engine-related issues with regards

to performance, power-rating, specifications, warranty and service. Please refer

to the engine manufacturer’s Owner’s/Operator’s Manual, packed separately

with your machine, for more information.

Thank You