Installation Sheet

11/28/20132
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
4. Connect the black fixture lead to the black wire in the outlet box.
Fasten the joined wires as in step 3.
.
5. Fasten the fixture to the wall use screws from up and down side.
6. Place the flat round glass into the ring under the socket.
7. Install the lamps ( light bulbs). NOTE: This fixture is rated for 100 watt type A lamp.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
8. Assemble the glass on fixture.
9. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Glass
Round glass
Bulb
Mounting ring
Green screw
Outlet box
Tap
Mounting screw screw