Installation Sheet

2 / 2
1/21/2016
4. Fasten the white fixture lead wire to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1” below the fastener, tightly wrap the connection
With electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the outlet box.
Fasten the joined wires as in step 4.
6. Using the set screw and sealing washers,
Fasten the fixture back plate to the outlet box.
7. Install the glass onto the frame with the thumb screw.
8. Install the lamps (light bulbs).
NOTE: This fixture is rated for Max 40 watt type G9 lamps. (included)
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Outlet box
Green screw
Mounting ring
Lamp
Back plate
Set Screw
Glass
Thumb screw
Frame