Installation Sheet

FIXTURE PREPARATION

1. Remove the fixture, parts and parts bag(s) from the carton.

NOTICE:

· Before discarding the carton, double check to

make certain that all parts are found.

CAUTION

· TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH

ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.

· INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR

CERTIFIED FACTORY TRAINED TECHNICIAN.

· If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.

DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.

In regular circumstances the BLACK wire will be the "Hot" lead and the WHITE wire will be the "Neutral" or "Common" lead

A GREEN or BARE COPPER wire is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the wiring.

B6181 ENIGMA SCONCE -01 INSTALLATION INSTRUCTIONS

WARNING

DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE

READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.

Page 1 of 2

NOTICE

· The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that

may occur. it must be understood that common sense, caution and care factors that cannot be built into any product.

Caution and care must be supplied by the person(s) installing, operating and caring of this lighting fixture.

· This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through wiring box

with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied

should be used. directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.

WARNING

Make sure that there is no exposed wire or strands

that could cause a dangerous short circuit!

NOTICE:

CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO

CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USE.

FIGURE-01

FIXTURE INSTALLATION

1. Attach the mounting plate w/ wing to the outlet box. The wings should be

orient horizontal. (The green screw should face against the wall).

Fasten the white fixture lead to the white wire in the outlet box.

Fasten the wires together with an approved fastener (wire nut). Starting about

1" below the fastener, tightly wrap the connection with electrical tape so that the

connections seals the end of the fastener.

JUNCTION BOX

MOUNTING PLATE

WALL

MOUNTING WING

TROY LIGHTING

PAGE 1
B6181 ENIGMA SCONCE -01 INSTALLATION INSTRUCTIONS TROY LIGHTING WARNING DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION. CAUTION · TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES. · INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
PAGE 2
Electrical tape FIXTURE Approved fastener ( wire nut ) JUNCTION BOX 3. Connect the black fixture lead to the black wire in the outlet box. Fasten the joined wires as in step 3. MOUNTING KIT W/ WING 4. Attach the fixture to the mounting plate with wing and secure it with flathead screws. (See Figure-02) 5. Install the lamps. (Type T-10 lamp) Incline the lamp and slide the tip to the empty ss cover until the position gets vertical then fasten it to the socket on the other ss cover.