Manualshelf

Installation Sheet

ManualsBrandsTroy Lighting ManualsLightingElliot 1-Light Textured Black 11.5 in. H Wall Sconce with Clear Glass
12
1 / 2
11/16/2017
B6221 INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
CAUTION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR
CERTIFIED FACTORY TRAINED TECHNICIAN.
If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regular circumstances the BLACK wire will be the "Hot" lead wire and the WHITE wire will be the "Neutral" or "Common" lead wire.
A GREEN or BARE COPPER wire is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the wiring.
NOTICE
The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that may occur.
It must be understood that common sense, caution and care are factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring for this lighting fixture.
This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through outlet box
with a plaster frame. The box must be securely mounted to the structure of the building.
The mounting bar and hardware supplied should be used. Directly mounting the fixture to the outlet box may make it impossible to
correctly align the fixture.
NOTE: For your safety be certain that the circuit breakers controlling outdoor lighting and equipment are GFI breakers
FIXTURE PREPARATION
1. Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
Before discarding the carton, double check to make certain that all parts are found.
FIXTURE INSTALLATION
1. (Starting at the back), thread the 2 longest screws into the mounting plate.
(The green ground screw is the front). Attach the mounting plate
to the outlet box. (The green screw should face out).
2. Fasten the ground wire to the green or bare copper wire
in the outlet box or to the green screw on the crossbar.
WARNING
Never fasten the ground wire to the black or "hot" wire!
Failure to follow this instruction could result in
serious injury or death!

Summary of content (2 pages)