Installation Sheet

2 / 2
1/27/2016
4. Fasten the white fixture lead wire to the white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut).
Starting about 1” below the fastener, tightly wrap the connection
With electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
5. Connect the black fixture lead wire to the black wire in the outlet box.
Fasten the joined wires as in step 4.
6. Using the set screw and sealing washers,
Fasten the fixture back plate to the outlet box.
7. Install the glass onto the fitter with the thumb screw and metal disk.
8. Place the glass shade onto the fixture ring.
9. Install the lamps (light bulbs).
NOTE: This fixture is rated for Max 40 watt type G9 lamps. (included)
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
10. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Outlet box
Green screw
Mounting ring
Set Screw
Glass Shade
Back plate
Fixture
Mounting Screw
Socket
Screw
Metal ring
G9 Lamp
Meta disk
Fitter