Installation Sheet

4/30/20142
the connection with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
5. Connect the black fixture lead to the black wire in the
outlet box. Fasten the joined wires as in step 4
6. To prevent water from flowing into the outlet box
put a bead of weatherproof caulking
or silicone sealant around the inside edge of the back.
DO NOT PLUG THE DRAIN HOLE !
7. Using the end balls and sealing washers, fasten the fixture to the outlet box.
8. Lift latch pin to open the fixture door.
A
nd install the
g
lass to fixture.
9. Install the lamps (light bulbs).
10. Install lamps (light bulbs). NOTE: This fixture is rated for 60 watt type B or CA lamps.
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
11. Close and latch the door.
12. Restore power to circuit at breaker or fuse box
electrical tape
approved fastener
(
wire nut
)
Outlet box
Crossbar
Green screw
Hex nut
Nipple
Glass
Screw
Latch