Installation Sheet

F5514 APOGEE 40"DIA 4LTS PENDANT INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
Page 1 of 6
TROY LIGHTING
Canopy
Adjustable stem
Ceiling
Swivel
SAFETY CABLE
Structure or Brace
Outlet box
Cable clip
Swivel Blocker
Small Hex Nut
Heavy duty Strap
Ball Nut
Stud
FIGURE-1
NOTICE
· The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that
may occur. it must be understood that common sense, caution and care factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring of this lighting fixture.
· This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through wiring box
with a plaster frame. The box must be securely mounted to the structure of the building. The heavy duty strap and hardware
supplied should be used. directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
· This fixture is supplied with with a 4-pcs. stem. There is one 6" section, two 12" section and one 18" section.
This feature allows the fixture to be mounted with a stem up to 48" in length in 6" increments.
· This fixture is supplied with a swivel. By rotating the canopy the fixture may be mounted to angled ceiling.
CAUTION
· TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
· INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR
CERTIFIED FACTORY TRAINED TECHNICIAN.
· If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER
WIRING. In regular circumstances the BLACK wire will be the "Hot" lead and the WHITE wire will be the "Neutral" or "Common"
lead. In older buildings it is always good practice to reconfirm the polarity of the wiring.
FIXTURE PREPARATION
1. Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
· Before discarding the carton, double check to
make certain that all parts are found.
FIXTURE INSTALLATION
1. Attach the SAFETY CABLE to the building structure or brace
(See figure-1).
WARNING
REFER TO THE ILLUSTRATION FOR CORRECT AND SAFE
INSTALLATION OF SAFETY CABLE. FAILURE TO FOLLOW THIS
INSTRUCTION COULD RESULT HARM/DAMAGE TO THE FIXTURE,
PROPERTY AND/OR PERSON(S)!
NOTICE:
THIS LUMINAIRE MUST BE MOUNTED OR
SUPPORTED INDEPENDENTLY OF AN OUTLET BOX.

Summary of content (6 pages)