Installation Sheet

2 / 2
7/29/2016
5. Fasten the white fixture lead to white wire in the outlet box.
Fasten the wires together with an approved fastener (wire nut). Starting about 1” below the fastener,
Tightly wrap the connection with electrical tape so that the connection seals the end of the fastener.
WARNING
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit!
6. Connect the black fixture lead to black wire in the outlet box. Fasten the joined wires as in step 5.
7. Place the canopy of the fixture over the screws and against the ceiling. Adjust the screws so that they extend 3/16" beyond the canopy
of the fixture. Lock the end nuts against the mounting ring
8. Install the lamps (light bulbs).
NOTE: This fixture is rated for Max 75 watt type T lamps.(Include)
WARNING
DO NOT EXCEED RECOMMENDED WATTAGE!
9. Put the glass onto the fitter well, tightening the set screw down fix the cup onto glass .
10. Restore power to circuit at breaker or fuse box.
electrical tape
approved fastener
(
wire nut
)
Set screw
Glass
End nut
Stem
Cup
Lamp
Ball swivel
Canopy
Fitter