Installation Sheet
1 / 2 1/24/2018
F6318 F6328 INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RELAMPING OR WIRING THE FIXTURE.
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
CAUTION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR CERTIFIED FACTORY TRAINED TECHNICIAN.
If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regular circumstances the BLACK wire will be the "Hot" lead wire and the WHITE wire will be the "Neutral" or "Common" lead wire.
A GREEN or BARE COPPER wire is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the wiring.
● This fixture weighs more than 50 lbs. It MUST be mounted on an APPROVED HEAVY DUTY outlet box or FIELD CONSTRUCTED
SUPPORT SYSTEM (see diagram page 2). The box and support must be securely mounted to the structure of the building.
● THE SAFETY OF EVERYONE WHO WILL OCCUPY THIS ROOM DEPENDS DIRECTLY
ON THE CORRECT INSTALLATION OF THIS FIXTURE!
NOTICE
The important safeguards and instructions outlined on this sheet cannot cover all possible conditions and situations that may
occur. It must be understood that common sense, caution and care are factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring for this lighting fixture.
This fixture is designed to be mounted on a correctly installed standard round or octagon box or a through outlet box
with a plaster frame. The box must be securely mounted to the structure of the building.
The mounting bar and hardware supplied should be used. Directly mounting the fixture to the outlet box may make it impossible to
correctly align the fixture.
● For your safety be certain that the circuit breakers controlling outdoor lighting and equipment are GFI breakers
● WITH MAXIMUM LAMPING THE FIXTURE WILL USE 960 WATTS! A standard 600 watt dimmer CANNOT BE USED. A 1000 WATT
DIMMER MUST BE INSTALLED
FIXTURE PREPARATION
1. Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
Before discarding the carton, double check to make certain that all parts are found.
2. Assemble the loop to the top of the fixture.
FIXTURE INSTALLATION
New construction: Double check that APPROVED BOX and SUPPORT
were correctly installed following the manufacturers instructions.
Remodeling (with enclosed ceiling) Install APPROVED BOX and SUPPORT
following manufacturer's instructions.
1. Determine the overall desired length of the fixture.
Guide the leads and ground wire from stems, ball swivel
to the center of canopy. Measure 6” of lead and ground
wire beyond the center of the fixture. Cut off excess wire.
Strip the insulation off the ends of the leads exposing
approx. 1/2” of wire. Twist the strands of wire together.