Manualshelf

Installation Sheet

ManualsBrandsTroy Lighting ManualsChandeliersRivington 6 Light 20" Wide Linear Chandelier
123
FIXTURE PREPARATION
1. Remove the fixture, parts and parts bag(s) from the carton.
NOTICE:
Before discarding the carton, double check to
make certain that all parts are found.
CAUTION
TO AVOID THE RISK OF FIRE OR SHOCK, FIXTURE MUST BE INSTALLED IN COMPLIANCE WITH
ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL/BUILDING CODES.
INSTALLATION AND MAINTENANCE OF THIS UNIT REQUIRES AN ELECTRICIAN OR
CERTIFIED FACTORY TRAINED TECHNICIAN.
If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixtu re was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regul ar circumstances the BLACK wire will be the "Hot" lead and the WHITE wire will be the "Neutral" or "Common" lead
A GREEN or BARE COPPER wire is the "Ground". In older buildin gs it is always good practice to reconf irm the polarity of the wiring.
F7237 RIVINGTON 6LT LINEAR INSTALLATION INSTRUCTIONS
WARNING
DISCONNECT POWER BEFORE RE-LAMPING OR WIRING THE FIXTURE
READ ALL INSTRUCTIONS COMPLETELY BEFORE STARTING INSTALLATION.
FIXTURE INSTALLATION
1. Attach the heav y duty strap unto the junction box.
(The green screw should face the floor). Place the heavy duty strap
at the junction box and fasten using the round
head screw . (See FIGURE-01.)
NOTICE:
CALIFORNIA PROP 65: THIS LIGHTING FIXTURE CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE CANCER, BIRTH DEFECTS, AND/OR OTHER REPRODUCTIVE HARM. WASH HANDS AFTER USE.
NOTICE
The important safeguards and instructions outlined on this sheet cannot cover all possible conditi ons and situations that
may occur. it must be understood that common sense, caution and care factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and caring of this lighting fixture.
This fixture is designed to be mounted on a correctly installed on 1/2-13 threaded rod secured to structure and standard round or
octagon box or a through wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The
heavy duty strap and hardware supplied should be used. directly mounting the fixture to the outlet box may make it impo ssible to
correctly align the fixture.
This fixture is supplied with a 16ft. aircraft cable .
FIGURE-01
HEAVY DUTY STRAP
CEILING
SCREW
THREADED
STUD
GREEN SCREWJUNCTION BOX

Summary of content (3 pages)