Manual

Maintenance
SPECIFICATIONS
Max Outlet Pressure ..................... 2550 psi
Max Flow Rate .......... 2.3 gallons per minute (gpm)
Detergent Use detergent approved for pressure washers
Water Supply ................ Not to Exceed l O0°F
Temperature
Automatic Coo[ ............. Will cycle when water
Down System reaches 125°- 155°F
ShippingWeight ........................... 75 Ibs
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warrant), does not cover items that
have been subjected to operator abuse or negligenceTo
receive full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual
NOTE: Should you have questbns about replacing
components on your Troy-Bi[t pressure washer, please call
1-888-611-6708 for assistance.
• Some adjustments wil[ need to be made periodically to
properly maintain your pressure washer.
• AH maintenance in this manual and the engine operator's
manual should be made at [east once each season.
• Once a year you should clean or replace the spark plug,
clean or replace the air filter and check the spray gun and
nozzle extension assembly for wear A new spark plug and
clean air filter assure proper fuel-air mixture and help your
engine run better and last longer Please refer to your
engine operator's manual for more details
Before
I. Check
2 Check
3 Check
4 Check
5 Check
6 Check
leaks
7
Each Use
engine oil level.
water inlet screen for damage
in-line filter for damage
high pressure hose for leaks
detergent siphoning tube and filter for damage
spray gun and nozzle extension assembly for
Rinse out garden hose to flush out debris
PRESSURE WASHER
MAINTENANCE
Check and Clean Inlet Screen
Examine the screen on the pump's water inlet Clean it if
the screen is clogged or replace it if screen is damaged
_h Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse Inspect the hose each time before using
ic Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings If any of these
conditions exist, replace the hose immediately
WARNING
NEVER repair high pressure hose Replace it
Replacement hose rating HUST exceed maximum pressure
rating of unit.
Check Detergent Siphoning Tube
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears Replace the filter or
tube if either is damaged
Check Gun and Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the trigger lock in the ON position and test the triggen
You should not be able to press the triggen
Check In-Line Filter
Refer to Figure 15 and service the in-line filter if it
becomes clogged, as follows:
Nozzle Extension
O-ring
4@