Manual

Storage
Data Tag
Data tag information is very important if you need help from
our Customer Service Department or an authorized service
dealer.
• The data tag (Figure 18) is located on the base of the
pressure washer. For future reference, please copy the
model, revision, and serial number of the pressure washer
in the space below.
MOOELi
REVNOi
S R,ALi
PSI i ]
O TRO RILT
Copy IVlodel
_" Number Here
_Copy Revision
Here
Copy Serial
Number Here
PREPARING THE UNiT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days, follow this procedure:
I. Flush detergent siphoninhg hose by placing filter into a
pail of clean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2. Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark plug wire
from spark plug.
3. Empty pump of all pumped liquids by pulling recoil
handle about 6 times.This should remove most liquid
in pump.
4. Use PumpSaver to prevent corrosion build up and
freezing of pump.
5. Store unit in a clean, dry area.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 6039, to treat
pump.This prevents freeze damage and lubricates pistons
and seals.
NOTE: PumpSaver is available as an optional accessory. It
is not included with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the PumpSaver
container.
CAUTION
• Failure to do so will permanently damageyour pump and
render your unit inoperable.
• Freeze damageis not covered under warranty.
,_ CAUTION
Always wear eye protection when using PumpSaver.
CAUTION
• Protect surfacesfrom dripping PumpSaven
NOTE: If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine operator's manual for instructions on how
to properly prepare the engine for storage.
O