Manual

Section 3: Assembly
Connect Hose and Water Supply to
Pump_
iMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
NOTE: Remove and discard the shipping caps from the
pumps high pressure outlet and water inlet before
attaching hoses.
I. Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 5).Tighten by hand.
_ hose here
2. Attach other end of high pressure hose to high
pressure outlet on pump (Figure 6).Tighten by hand.
4. Run water through your garden hose for 30 seconds
to clean out any debris.
iMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
5. Connect the garden hose (not to exceed 50 feet in
length) to the water inlet.Tighten by hand (Figure 7).
CAUTION
Damage to equipment resulting from failure to follow this
instruction will void warranty.
Turn ON the water and squeeze the trigger on the
gun to purge the pump system of air and impurities.
WARNING
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washet, be sure you are wearing
adequate safety goggles,
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 7). Clean screen if it contains
debris or have it replaced if damaged. DO NOT RUN
PRESSUREWASHER IF INLET SCREEN IS DAHAGED
OR HISSING.
\\ screen, DO NOT
use if damaged;
clean if dirty.
Inspect inlet
Checklist Before Startin EgEn_ine
Review the unit's assembly to ensure you have performed
all of the following.
I. Hake sure handle is in place and secure.
2. Check that oil has been added to proper level in the
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properly tightened hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo UseYour
Pressure Washer" before using pressure washer.
O