Manual

Section 4: Operation
For maximum rinsing (higher pressure and lower
fiow)_ for stubborn or hard to reach surface such
as second story surfaces_ paint removal oiHstains_
rust removal or other stubborn substances (tar,
gum_grease_wax, etc.)_ sdect red 0° ProjectPro TM
nozzHe (Figure H6).
To apply chemical applies pro[ect specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black Pro[ectPro Tu
cleaning detergent nozzle (Figure [7).
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.Always start the turbo nozzle at a
distance_ gradually getting closer to the surface until you
get the cleaning force you want.
CAUTION
Always make sure the surface you will clean will not be
damagedby the high pressure spray by _esdngin a hidden area_
I. Pull back collar on quick-connect and pull current
ProiectPro TM nozzle off. Store ProjectPro TM nozzles in
holder provided on the accessory tray.
2. Pull back on collar_insert turbo nozzle and release
collar (Figure 18).Tug on turbo nozzle to make sure it
is securely in place.
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too dose_ you may damage cleaning surface.
NOTiZ: Detergent cannot be applied with turbo nozzle.
How to Use the Rotating and Utility
4. Pull back on collan insert selected ProiectPro TM nozzle
and release collar.Tug on ProiectPro TM nozzle to make
sure it is securely in place.
5. For most effective cleaning, keep ProiectPro TM nozzle
from 8 to 24 inches away from cleaning surface. If you
get the nozzle too close, you may damage the cleaning
surface.
6. DO NOT get closer than 6 inches when cleaning tires.
The rotating and utility brushes allow you to scrub surfaces
with water filtering through the bristles.
To attach a brush to the gun:
[. Tighten adapter to Other brush base.
2. Remove nozzle extension from spray gum ff attached.
3. Attach brush with adapter to spray gun.Tighten by
hand (Figure [9).
NOTE: You must use the adapter to attach the utility or
rotating brush to the spray gun.