Manual

Section 3: Assembly
2, Insert carriage boks through holes from outside of unit
and attach a phstic knob from inside of unit (Figure 2).
Tighten by hand.
%
3, Place accessory tray over holes on handle (viewing
from front of unit). Pushthe tree clips into the holes
until they sit fiat againstthe accessory tray (Figure 3).
4, Insert"L" bolt through hole just above billboard on left
side of handle (viewing from front of unit). Hold bolt in
place and attach a plastic knob from inside of unit
(Figure 4).Tighten by hand.
!l
Spray Gun Hook
5, Insert muki-colored ProjectPro TMnozzles and other
supplied accessories in spaces provided in accessory
tray, See "How to Use AccessoryTray',
Add [_rig[ne Oil and Fuel
° Place pressure washer on a [eve[ surface,
Refer to engine manual for oil and fuel fill information.
- Damage to equipment resulting from failure to follow this
instruction will void warranty.
" Refer to engine owner's manual and follow oil and fuel
recommendations and instructions,
NOTE: Check oil often during engine break-in, Refer to
engine owner's manual for recommendations,
O