Manual

Section 3: Assemb(y
Connect Hose and Water Supp)y to
iMPORTANT: To avoid pump damage, you must assemb(e
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
NOTE: Remove and discard the shipping caps from the
pumps high pressure outlet and water inlet before
attaching hoses.
I. Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure S).Tighten by hand.
hose here
2. Attach other end of high pressure hose to high
pressure outlet on pump (Figure 6).Tighten by hand.
Before connecting garden hose to water inlet, inspect
inlet screen (Figure 7). Clean screen if it contains
debris or have it replaced if damaged. DO NOT RUN
PRESSURE_CCASHERIF INLET SCREEN IS DAMAGED.
Inspect inlet
screen, DO NOT
use if damaged;
clean if dirty.
4. Run water through your garden hose for 30 seconds
to clean out any debris.
mMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than [O0°F).
5. Connect the garden hose (not to exceed 50 feet in
length) to the water inlet.Tighten by hand (Figure 7).
Damage to equipment resulting from failure to fol)ow this
instruction will void warranty.
Turn ON the water and squeeze the trigger on the
gun to purge the pump system of air and impurities.
WANNING
Always wear eTe protection when using this equipment or in
vicinit 7 of where equipment is in use.
Before scarring she pressure washer,be sure you are wearing
adequate eye protection.
Cheddist Before Startin E_L_Sine
Review the unit's assembly to ensure you have performed
all of the following.
I. Hake sure handle is in place and secure.
2. Check that oil has been added to proper level in the
engine crankcase.
3. Add proper fuel to fuel tank.
4. Check for properly tightened hose connections.
5. Check to make sure there are no kinks, cuts, or
damage to high pressure hose.
6. Provide a proper water supply at an adequate flow.
7. Be sure to read "Safety Rules" and "HowTo UseYour
PressureVVasher" before using pressure washer.
O