Manual

Section 4: Operation
For maximum rinsing (higher pressure and lower
fiow)_ for stubborn or hard to reach surface such
as second story surfaces, paint removal oil stains_
rust removal or other stubborn substances (tar,
gum, grease_ wax_ etc.)_ select red Hax
ProjectPro TMnozzle (Figure 16).
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.Always start the turbo nozzle at a
distance_ gradually getting closer to the surface until you
get the cleaning force you want.
CAUTION
Always make sure the surface you will clean will not be
damagedby the high pressure spray by testing in a hidden area.
Pull back collar on quick-connect and pull current
ProjectPro TM nozzle off. Store ProjectPro TM nozzles in
holder provided on the accessory tray.
Pull back on collar_ insert turbo nozzle and release
collar (Figure 18).Tug on turbo nozzle to make sure it
is securely in place.
To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black ProjectPro TM
cleaning detergent nozzle (Figure 17).
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close_you may damage cleaning surface.
NOTE: Detergent cannot be applied with turbo nozzle.
How to Use the Rotating and Utility
4. Pull back on collar, insert selected ProjectPro TMnozzle
and release collar.Tug on ProjectPro TMnozzle to make
sure it is securely in place.
5. For most effective cleaning, keep ProjectPro TM nozzle
from 8 to 24 inches away from cleaning surface, ff you
get the nozzle too c[ose_ you may damage the cleaning
surface.
6. DO NOT get closer than 6 inches when cleaning tires.
The rotating and utility brushes allow you to scrub surfaces
with water filtering through the bristles.
To attach a brush to the gun:
1. Remove nozzle extension from spray gum if attached.
2. Attach brush to spray gun.Tighten by hand (Figure 19).