Manual

Fig. 2-3: Wheel in FREEWHEELposition
STEP4: INSTALL FORWARD
CLUTCH CABLE
1. Attach the forward clutch cable bracket
(P, Fig.2-4) to the handlebarsupport AI
with a 1/4"-20 x 1-1/42hex hd. screw (R)
and V4"-20 hexIocknut (S). Tightense-
curely.
2. Carefully unwrap the forward clutch ca-
ble (cable without anattached knob, from
its shipping position and slide the thin ca-
ble wire (T.Fig.2-4 into the slot in the ca-
ble bracket. Push the cable connector (U.
Fig.2-4) upthrough the holein the bracket
until the groove in the connector snaps
into place.
3. Insert the #10-24 x 2" slotted hd. screw
(V, Fig.2-5) down through the hookedend
of the cable spring (W) until the screw
Fig.2,2:AHachhandlebar, threads extendthrough the spring.
2. Removethe hairpin cotter (L, Fig.2-3)
and wheel drive pin (M) from the wheel
hub (0) and wheel shaft (N).
3. Slidethe wheelfully inward onthe wheel
shaft (N, Fig.2-3). Reinstallthe wheel
drive pin (M) through the wheel shaft only
(not through the wheel hub). Securethe
wheel drive pin with the hairpin cotter (L),
pushing the hairpincotter in asfar as it will
go. Thewheel should now spin freely
(freewheel) on the wheel shaft. Repeat
with the other wheel.
4. Usethe handlebarto roll the tiller to a
flat area.
IMPORTANT: Before starting the engine,
the wheels must be placedin the WHEEL Fig.2=4:Installingforwardclutchcablebracketandcable.
DRIVEposition (pins through wheel hubs
andwheel shaft). This procedure is
described in WheelDrive Pins in Section3.