Manual

i 'munmmmBw,_,
Operator'
®
T
2-Cycle
Electric Start Capable
Handheld Blower / Vacuum
RemovingUnit FromCarton
Remove all contents from
carton.
AssembleThe Unit
) t
Place the unit on a level
surface. Fill the fuel tank.
AssembleThe Unit
Insert the upper blower
tube into the blower outlet
and turn it clockwise until
it locks into place.
]
j
Install the lower blower tube
onto the upper blower tube
and turn it clockwise until it
locks into place.
Starting The Unit
Primer L
) J
Press the primer bulb 10
times, or until fuel is visible.
]
fChoke_er E
Move the choke lever to
Position 1.
]
E
I Gallon 3.2 oz
Mix thoroughly in a separate
fuel can:
- 3.2 fl. oz. of 2-cycle
engine oil
- 1 gallon of unleaded
gasoline
NOTE: Do not mix directly in
the fuel tank.
Tools Required:
Flathead Screwdriver
Handle
"°°°'
Cruise Control _ ,__ _
Starter Rope
Upper Blower Tub
_._ cover__
_Z/ P.merBu,b_
_ Fuel Cap
Lower Vacuum Tube
Upper Vacuum Tube
Choke Lever
Starting The Unit
f
)
Crouch in the starting
position.
E]
DO NOT squeeze the
trigger.
]
f
Do not squeeze the
trigger. Pull the rope 5
times.
Do not squeeze the
trigger. Move the choke
lever to Position 2.
E]
Elbow
Bag Strap
Vacuum Bag
__ Zipper
Starting The Unit
f
Do not squeeze the
trigger. Pull the rope 3-5
times to start the engine.
E] E
,j
Squeeze the trigger, or
press down the cruise
control, and allow the unit to
warm up for 30-60 seconds.
L]
Continue to squeeze the
trigger, Move the choke
lever to Position 3. Warm
the unit for an additional 60
seconds. The unit may be
used during this time.
Need Help?
Call 1-800-828-5500
DIDN'T START?
Repeat the starting instructions.
IF engine fails to start after2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF unit still fails to start, refer to the
operator's manual for additional starting
and troubleshooting information
n
I
_m
C
uJ
it)
n
I
C
I,L
n
I
m
O
_C
o_
¢0
uJ
NEED HELP? CALL 1-800-828-5500 iN U.S. OR 1-800-668-1238 iN CANADA
769-07209 P00 06/11

Summary of content (16 pages)