Installation Instructions

Page 11

Unlock / Valid programming: 1 long beep and LED illuminates green

Lock: 2 short beeps and LED illuminates red

Invalid Programming: 2 short beeps and LED ﬂashes red twice

Low Voltage: Beeps for 5 seconds

(7/9 times depends on operation is unlock/lock)

Super Low Voltage: 4 short beeps and LED ﬂashes red four times

4 Incorrect code entry attempts: 2 short beeps and LED illuminates red each attempt

Power on: 1 long beep and 1 short beep and LED illuminates green

Chip Reset: 1 long beep and 1 short beep and LED illuminates green

(may occur several times or once in a while)

Lock Error: 3 long beeps LED ﬂashes red three times

Repeat operation after Lock Error: 2 short beeps three times LED ﬂashes red six times

Issue Solution

Lock will not function

electronically

• Check that all batteries are fresh high quality

Alkaline Batteries

• Check for proper polarity (+ -) of all batteries

• Check that the Control Wire is attached to the

Interior Assembly

Latch is sticking.

Installation screws of the lock may be too tight and have to be

loosened

• Remove Interior Assembly

• Slightly loosen the Mounting Plate Screws

• Lock and unlock using the Key

• Reattach Control Wire and Interior Assembly