User manual

7. Selecting Start Program

First remove the plastic cover by lifting it

upwards. To do so, press the individual

attachment notches on the edge of the

housing slightly inwards so that the cover

comes away from the base of the unit.

There are 4 jumper bridges on the circuit-

board J1, J2, J3 und J4, as shown on the

upperrightoftheadjacentgure.

These jumper bridges allow you to select

one of the lighting programmes which

will be activated automatically when the

power supply is attached.

The speed of the lighting program can

be selected with the "S-POT" dial, use a

suitable screwdriver to set the dial.

The following levels can be selected:

1 x, ½ x , ¼ x, 1/16 x, 1/64 x, 1/128 x

base speed (direction.: max. -> min.)

In the following table "x" indicates an attached jumper. A description of the lighting programs is

available on the next page.

J1 J2 J3 J4 Function

x - - - Colour change (slow fading)

- x - - Colour change (no hold time)

x x - - Tempest

- - x - Fireplace

x - x - Sunrise and sunset

- x x - Colourashes

x x x - User program 1

- - - x User program 2

All other jumper combinations activate colour change at normal speed.