User manual

12. Connection to a Computer

Before you connect the controller and computer install the driver software for the USB

programming adapter (Conrad item no. 197339) and then the controller software.

• First remove the controller‘s plastic cover by lifting it up-

wards. To do so, press the individual attachment notches

on the edge of the housing slightly inwards so that the

cover comes away from the base of the unit.

• Connectthe"PROG"socketonthecontroller(seegure

on the right) to a free USB port on the computer using the

programming adapter.

Windows recognises the new hardware when it is con-

nectedforthersttimeandcompletestheinstallationof

the required drivers.

• In the Windows Control Panel (in Device Manager) you can check which COM port has been

assignedtotheUSBprogrammer(inthegurebelowitis"COM3").ThisCOMportshould

be set after the software starts (see chapter 13), so that the software can make a connection

with the controller via the USB programmer.