Data Sheet

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 2201308, 2201309, 2201310, 2201311
Material Safety Data Sheet
8.2 Exposure controls
Based on the composition shown in Section 3, the following measures are suggested for occupational safety
measure
Appropriate engineering controls
See Section 7 for information about design of technical facilities.
Personal protective equipment
Respiratory protection:
Suitable respiratory protective device recommended.
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/the chemical
mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation.
Material of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from
manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can
not be calculated in advance and has therefore to be checked prior to the application.
Penetration time of glove material:
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed.
Eye protection:
Tightly sealed goggles
Environmental exposure controls:
Control measures must be made in accordance with Community environmental protection legislation.
Page 5 of 10