User Manual

After the bracket is attached to the stand now you can
attach the speaker to the stand. The easiest way is to
place the speaker face down on your lap and attach the
stand to the back of the speaker with the provided
hardware.
Connect the speaker cable: Strip back the insulation on
each conductor to show the bare copper wire. We
suggest stripping enough so that 3/8” of copper wire is
showing. Push down each post and insert the speaker
cable. The posts will be located on the back of the
speaker on the crossover. Make sure that only BARE wire
is touching the speaker post once it slides back into place.
All TruAudio products feature gold push binding posts
which are quick and simple to use and also are great for
UP 11º
STRAIGHT
DOWN 11º
conducting speaker signal, also make sure to tuck wires
into the track on the bottom of the speaker so that you get
a flat, slim installation.
When connecting the other end of the speaker cable to
the amplifier or receiver make sure to observe the same
polarity as you did at the speaker connection.
Cleaning the speaker:
The SLIM Series feature a highly durable aluminum
finish. When needed, we suggest cleaning with a damp
cloth with water only. Do not use any kind of abrasive
cleaners or detergents.