Instructions / Assembly

Instruction Manual
Mini pendant Lighting
Overview
Assembly Instruction
Wiring Instruction
Product Specifications
Input voltage 120V
Rated power 40W MAX
Lamp socket E26
Product Packaging
CONTACT US
E-mail:[e-mail]
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders, steel
wool or abrasive paper.
1. Insert the green grounding screw into the hole with two raised
dimples on the mounting bar. Wrap the ground wire from the fixture
(if supplied) around the green grounding screw, then connect it to
ground wire from the outlet box (if not fixed on the outlet box) using a
wire connector(not supplied). If ground wire from the fixture is not
supplied, wrap the ground wire (if not fixed on the outlet box) from the
outlet box around the green grounding screw and tighten it.
2.Take note of the color of the wire(s) on your fixture. Identify which
group your fixture wire(s) falls into and connect the wires according
to the directions below:
6.Connect the fixture wire from [Group B] to the white wire from the
outlet box in the same manner. Make sure no bare wires can be seen
outside wire connectors.
5.Try gently to pull the connector off the wires. If you can pull the
connector off, carefully re-do steps 3 and 4 as above, and check again
for a firm connection.
3.Take your fixture wire(s) from [Group A] and place evenly against the
black wire from the outlet box. Do NOT twist wires together before
using wire connectors.
4.Fit a wire connector over the wires and screw the connector
clockwise until you feel firmness.
Always switch off the electricity supply and allow to cool for 10 minutes
before changing the light bulbs.
Fixture body × 1
Mounting strap × 1
Screw × 2 & Wire nut × 3
Shade × 1
Lamp instruction × 1
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
[GROUP A]:
Connect to Black House Wire
[GROUP B]:
Connect to White House Wire
BLACK WHITE
*PARALLEL WIRE (round & smooth) *PARALLEL WIRE (square & ridged)
WHITE OR GREY WITH TRACER WHITE OR GREY WITHOUT TRACER
BROWN, GOLD OR BLACK
WITHOUT TRACER
BROWN, GOLD OR BLACK
WITH TRACER
Cleaning
Safety Information
Print in china
2.Fix Mounting strap (F) to outlet box with Screw (G).
3.Connect the wires according to the picture above.
(Please refer to the wiring instruction for details )
4.Pass Canopy (E) through the screw and fix it with Finial (D).
1.Attach Shade (B) up onto the socket , then tighten with
Socket ring (C).
Green(Ground)
Bare copper wire(Ground)
D.Finial
A.Fixture body
B.Shade
C.Socket ring
E.Canopy
G.Screw
F.Mounting strap
[GROUP B]
White
Ribbed
Outlet box
[GROUP A]
Black
Wire nuts
Smooth