Owner Manual

Power sharing
• When two heang zones are turned
on, will create a totla max 10 seng
Transistor) overheang.
• See POWER SHARING
Error Code Possible Cause
“E0” appears in the
Timer display
•
•
unit.
“E1” appears in the
Timer display
• No cookware found or improper
placement of cookware on the
cooking zone.
• Make sure the cookware is centered on the
cooking zone, and that it’
“E2” appears in the
Timer display
• Supplied voltage to cooktop is too
low.
• If the voltage of the power supply to the cooktop
is too low, it cannot operate properly and will
show this error code.
This may be caused by reduced voltage being
are correct and supplied voltage returns to
normal, the code will disappear.
“E3” appears in the
Timer display
• Supplied voltage to cooktop is too
high.
• If the voltage of the power supply to the cooktop
is too high, it cannot operator properly and will
show this error code.
This may be caused by increased voltage being
are correct and the supplied voltage returns to
normal, the code will disappear.
“E7” appears in the
Timer display
• NTC1 (To check the temperature of
IGBT) break off
• Turn OFF the cooktop; then shut off the power at
the fuse or circuit breaker for about 30 seconds.
Turn the power back on to the cooktop then
service.
“E8” appears in the
Timer display
• NTC1 (To check the temperature of
IGBT) short circuit
“E9” appears in the
Timer display
• NTC2 (to check the temperature of
heang center) break off
“EE” appears in the
Timer display
• NTC2 (to check the temperature of
heang center) short circuit
12
(Insulated Gate Bipolar