Installation Instructions and User Guide

TRUE RESIDENTIAL

SOLID (OP) AND GLASS FRAMED PANEL (OG) INSTALLATION

Required Tools:

• Phillips Screwdriver

• 3/8" Wrench

• 1/8" Drill Bit

• Ten (10) Screws #6

SEE PAGES 21-22 FOR OVERLAY PANEL DIMENSIONS

BEFORE INSTALLING.

FOR EASY OVERLAY INSTALLATION REFRIGERATOR

DOOR REMOVAL IS REQUIRED.

NOTE: DO NOT INSTALL A SOLID PANEL ON A

GLASS DOOR. THIS MAY CAUSE MOISTURE

TO FORM BEHIND THE PANEL RESULTING IN

DAMAGE.

1. Open front door and pull grill forward to remove.

2. To remove door back out two bottom hinge screws

with a 3/8" wrench. Secure door while removing

screws. Remove two Phillips screws from the top

hinge. Save all these screws for later reinstall.

3. Lay door on a safe solid surface. If retrofitting

glass door model be careful not to damage glass.

Lay cardboard or other safe material down before

working on the door. Remove door gasket from the

inside of the door frame. Place gasket to the side

for later reinstall.

4. There are pre marked areas on the front of the

door. Drill these pre marked holes with 1/8" drill

bit. Make sure to go all the way through the door.

NOTE: IF HANDLE IS BEING USED ON OVERLAY

INSTALL IT BEFORE STEP 7 (SEE IMAGE

A). FOR BEST INSTALLATION, SCREWS

ATTACHING HANDLE SHOULD BE RECESSED.

5. It is recommended to clamp the door front on top of

the overlay before drilling pilot holes and installing

anchor screws. The clamp ensures the overlay

panel and door stay aligned with each other while

installing. Once panel is clamped in place, pilot

holes may be drilled into the panel from the rear

side of the door.

Remove screws

from top and

bottom hinge