Installation guide

29
THE TRUE 42 / 48
DRAWERS
To remove a drawer, pull drawer forward until it stops. Use a Phillips screw driver to remove the two (2) screws
securing the drawer to the slides, then lift the drawer up and out of unit. (See Figure 19). To reinstall, pull drawer
slides all the way forward on unit, and then slide the drawer onto the slides until the hook on the back of the
slide is over top of the drawer, reinstall the screws using the Phillips screw driver.
Figure 19
FREEZER STORAGE
WIRE SHELVES
Remove the top foam piece holding the wire shelves. Carefully remove shelves and set aside. (See Figure 20).
Remove all other packing material. To install, insert wire shelf into the shelf standards on the back wall, with the
front tilted upward, and then lower the front until it stops. (See Figure 21). To remove or adjust a wire shelf, tilt
up, and then lift up and out.
FIGURE 20 FIGURE 21 Final Wire Shelf Installation
WIRE BASKETS
To remove a basket, pull drawer forward until it stops. Use a Phillips
screw driver to remove the two (2) screws securing the basket to the
slides, then lift the basket up and out of unit. To reinstall, pull drawer
slides all the way forward on unit, and then slide the basket onto the
slides until the hook on the back of the slide is over top of the rails,
reinstall the screws using the Phillips screw driver. (See Figure 22).
Figure 22