Manualshelf

Installation and User Guide

ManualsBrandsTrue Residential ManualsAll Refrigerator- No Freezer30 Inch Refrigerator Column with 19.7 cu. ft. Capacity, True Precision® Control, Stainless Steel Interior, Ramp Up Lighting, Forced Air Refrigeration System, and Soft Close Bins: Stainless Steel, Right Hinge
41424344454647484950
TRUE RESIDENTIAL
®
TEC_TM_009 Rev. B
December 31, 2019 Page 44 of 50
DOOR BINS
The door bins are located in the bottom drawer of the refrigerator. To install, push tabs into the slots in the door
and slide downward unit it stops. To remove or adjust a door bin, lift up and away from door back.
NOTE: BE CAUTIOUS OF PLACING TALL ITEMS IN TOP DOOR BIN, AS ITEMS MIGHT INTERFERE
WITH UI CONTROL PANEL.
REFRIGERATOR STORAGE
GLASS SHELVES
Remove the top foam piece holding the glass shelves. Carefully remove shelves and set aside. Remove all other
packing material. To install, insert glass shelf into the shelf standards on the back wall, with the front tilted
upward, and then lower the front until it stops. To remove or adjust a glass shelf, tilt up, and then lift up and out.
All shelving and door bins come packaged inside the unit.
FINAL GLASS SHELF INSTALLATION
FINAL DOOR BIN INSTALLATION
SHELVING
DRAWERS
To remove a drawer, pull drawer forward until it stops. Use a Phillips screw driver to remove the two (2) screws
securing the drawer to the slides, then lift the drawer up and out of unit. To reinstall, pull drawer slides all the
way forward on unit, and then slide the drawer onto the slides until the hook on the back of the slide is over top
of the drawer, reinstall the screws using the Phillips screw driver.