Install Guide and User's Manual

68
TRUE RESIDENTIAL
®
TRUE STACKING KIT FOR UNITS WITH OVERLAY PANELS
REQUIRED TOOLS:
• 1/4 inch socket and ratchet
• Level
• Floor protector
KIT:
• (2) Stacking Brackets
• (4) 1/4" Hex Head Screws
1. Lay floor protectant down.
2. Uncrate cabinets and secure both shelving
and doors/drawers.
3. Install the anti-tip device per its instructions.
(Page 16).
4. Trial fit anti tip brackets using the lower
cabinet.
5. Carefully lift the top cabinet and place on
the lower cabinet. This procedure requires
assistance. Level the top cabinet.
6. Position the upper refrigerator so that it is
flush with the lower cabinet’s sides and back.
7. Install the rear stacking brackets.
See image 1.
8. Place set in final spot. Level both top and
bottom unit. Use a level on the inside of the
cabinets. Check front to back and side to side.
See image 2.
9. Installation is complete.
2
1
STACKING
BRACKETS