Owner's Manual

CHAPTER 2: ASSEMBLY INSTRUCTIONS
ELLIPTICAL ASSEMBLY STEPS (continued):
Optional Power Supply Installation:
a)
Take off eight T-25 screws holding
inner right front cover plate. Remove
plate.
b) Cut wire tie holding two cables to
frame support.
c)
Firmly plug Power Cord (installed
from factory) into Auxiliary Power
Supply.
d) Firmly plug smaller AUXPS Cable
(pre- installed in machine) into Power
Supply cable.
e)
Secure Power Supply and excess
wiring with two wire ties as shown.
f) Re-attach inner front right plate with
eight T-25 screws.
Cut Wire
Tie
Power Cord
AUXPS
Cable
Power Supply
Cable
Truefitness.com / 800.426.6570 / 636.272.7100 14