Spec Series Manual

8
A. Before your new unit is connected to a power supply, check the incoming voltage with a voltmeter. If anything
less than 100% of the rated voltage for operation is noted, correct immediately.
B. All units are equipped with a power cord, and must be powered at proper operating voltage at all times. Refer to
cabinet data plate for this voltage.
TRUE requires that a sole use circuit be dedicated for the unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - locate the diagram on the junction box cover.
ELECTRICAL INSTRUCTIONS