Spec Series Manual

20
• Disconnect power supply.
CAUTION:
Before performing service or maintenance make sure louver grill is secured in open position.
Use instructions and photos below to secure louver grill.
1. Remove thumbscrews on the top of each cabinet end.
2. Lift louver grill (careful not to pull on any wires)
3. Reinstall thumbscrews
A. The thumbscrews should be put through louver grill
holes and fastened into previous position in cabinet end.
CAUTION:
Make sure top louver grill is correctly
seated in the open position when servicing or
cleaning.
B. When servicing is complete remove thumbscrews and close louver grill. Then reinstall thumbscrews into original
location.
•
While cleaning condenser coil lift and hold top louvered grill. Clean off accumulated dirt from the condenser
coil with a stiff bristle brush. Vacuum all dirt residue from the coil and surrounding areas while holding the
top louvered grill. Any servicing to condensing unit remove top louvered grill. On top of the cabinet are two
screws are located on either side of the louver grill. Remove these screws from the hinges and keep them in a
safe place while servicing the unit. These screws are needed for later re-install of the louver grill.
MAINTENANCE, CARE & CLEANING
CLEANING THE CONDENSER COIL
When using electrical appliances, basic safety precautions should be followed, including the following:
Condenser Cleaning
Thumbscrew Location
Louver grill in upright position
Thumbscrews located
on cabinet ends