Instruction Manual

SPEC SERIES

TEC_TM_141 | REV. A | EN

06/30/2022 Page 13 of 24

www.truemfg.com

Cabinet Setup (cont.)

Shelf

Standards

Shelf

Clip

Shelf

WARNING – DO NOT use pliers or

any crimping tools when installing

shelf clips. Altering shelf clips in any

way can lead to shelving instability.

Shelf Standard Installation (Kit #4)

1. With the provided hardware, secure the shelf standards to the

cabinet side walls. Hook the shelf clips into the shelf standards.

See fig. 1.

2. Push up on the bottom of the clip. See fig. 2.

NOTE: You may need to squeeze or twist the bottom of the

shelf clip for proper installation. Position all four shelf clips

equal in distance from the floor for flat shelves.

3. Ensure the shelf clip is not loose or able to wiggle out of the

shelf standard. See figs. 3 and 4.

4. Place the shelves on the shelf clips with the cross support bars

facing down.

NOTE: Be sure all shelf corners are properly seated.

Installation Tips

• Install all the shelf clips before installing any shelves.

• Start at the bottom shelf and work your way up.

• Always lay the back of each shelf down on the rear clips before

the front.

Fig. 1. Installing top tab of shelf clip. Fig. 2. The bottom tab of the shelf clip

will fit tightly

Fig. 3. You may need to squeeze or twist

the bottom of the shelf clip to install.

Fig. 4. Installed shelf clip.