Instruction Manual

SPEC SERIES www.truemfg.com
TEC_TM_141 | REV. A | EN06/30/2022 Page 16 of 24
Cabinet Operation
Startup
• The compressor is ready to operate when the unit is purchased.
All you need to do is plug in the cooler.
• Excessive tampering with the control could lead to service
difficulties. If replacing the temperature control is ever needed,
be sure to order the replacement from your TRUE dealer or
recommended service agent.
• Good air flow inside your TRUE unit is critical. Take care to
prevent product from pressing against the sides or back
wall and coming within 4" (101.6 mm) of the evaporator
housing. Refrigerated air off the evaporator coil must circulate
throughout the cabinet for even product temperatures.
NOTE: If the unit is disconnected or shut off, wait 5 minutes
before restarting.
RECOMMENDATION – Before loading product, run your TRUE
unit empty for 24 hours to verify proper operation. Remember,
our factory warranty DOES NOT cover product loss!
Electronic Temperature Control
On the front of grill.
Light Switch
Behind the front louver grill
Temperature Control & Light Switch Location
The light symbol shows the approximate location of the light
switch.
The electronic temperature control can act as a light switch.
To control the light, press the up arrow .
FOR MORE INFORMATION
For more information regarding a cabinet's temperature control adjustment or general sequence of operation,
please see our Temperature Control Adjustment—Sequence of Operation Manual in our resource library at
https://www.truemfg.com/Service-Manuals/Sequence-of-Operation or follow the QR code.
ECO
°C
°F