Use and Care

10
True
traditional reach-ins
www
.truemfg.com
STEP 7-Letthedoorcordslowlyretractbackintothedoorside
channel.
STEP 8 - When reinstalling door, make sure door cord grommet
attaches to roller slot closest to pulley. See image 9.
STEP 5 - Slide left door to the right so right edge lines up with the
end of theTRUE Logo located at the top of the door frame. See
image 6. Then lift door out of track same way as image 4.
(ThreeDoorUnitsONLY)
TRUELogo
6
NOTE: Door cord will either be nylon cord or metal cable.
STEP 6 - Remove door cord from roller bracket. The black plastic
tabholdingthedoorcordslidesouttheback.Seeimages7&8.
TO ADJUST SLIDE DOOR
STEP 1 - After cabinet is installed in a final location and correctly
leveled check for any openings when the slide doors are completely
closed. If there are any gaps/openings between the closed doors and
cabinet, the doors will need to be adjusted.
STEP 2-Usinga7/16"wrenchoradjustablewrenchand1/8"Allen
wrench loosen roller and move along slotted hole. After adjustment
has been made tighten the roller into place. See image 10.
10
7
Door roller bracket with metal cable.
8
Door roller bracket with nylon cord.
9
Door closing to the left
SLIDE DOOR UNITS WITH HOLD OPEN FEATURE
These instructions explain how to keep door in open position.
A. Slide the door open.
B. Latchthedoorintheopenpositionfromthebacksideofdoor
(notch in track).
C. Door latch in image 1 is in the open position.
D. Door latch in image 2 is in the closed position.
Rear view of door & track
1 2