User's Manual

15 INCH & 24 INCH INSTALL GUIDETEC_TM_070 REV. B 02/03/2021 Page 27 of 74

REQUIRED TOOLS

• Phillips Screwdriver

• 1/8" Drill Bit

SEE PAGE 21 FOR OVERLAY PANEL DIMENSIONS

BEFORE INSTALLING.

FOR EASY OVERLAY INSTALLATION, DRAWER FRONT

REMOVAL IS REQUIRED.

PROCEDURE

1. Open the drawer and detach the front drawer panel

by removing four #2 Phillips screws (two on each

side). (See image 1). Save all these screws for later

reinstallation.

2. Remove front drawer panel gasket.

3. Using a 1/8" drill bit, drill out the eight pilot holes

(each drawer) from the front of the drawer panel. Drill

completely through the panel.

4. Attach drawer handle to the front of the overlay

panel. Attach handle before step 5.

5. Lay overlay panel face-down on a safe solid surface.

Lay drawer panel face-down on top of the overlay

panel. Align panels and secure with a clamp. Lay

cardboard or other soft or safe material down before

working on drawer front.

Front of

drawer

DRAWER OVERLAY PANEL INSTALLATION