User's Manual

TRUE RESIDENTIAL
®
TEC_TM_070 REV. B02/03/2021Page 60 of 74
ANTI-VIBRATION
BUMPERS
WINE SHELVING ADJUSTMENT
The glide out wine shelves in TBC, TWC and TWZ-DZ
models consist of 3 pieces. These pieces are the wire
wine rack and 2 mounting bracket/glide assemblies
(one for the hinge side and one for the non-hinge side).
To remove the wine shelf, pull up on the front of the
wine rack and it will separate from the two mounting
brackets. The two mounting brackets may now be
removed from the pilasters by lifting straight up then
pulling the brackets out of the pilasters.
NOTE WHEN REINSTALLING THE BRACKETS, THE
BRACKET WITH THE LARGER VIBRATION BUMPER
MUST BE INSTALLED ON THE SAME SIDE OF THE
CABINET AS THE DOOR HINGE. WHEN REINSTALLING
THE WINE RACK, BE SURE THAT THE BACK OF THE
RACK HOOKS UNDERNEATH THE TAB ON THE GLIDE.
The tab on the front of the glide must also fit securely
in the gap between the handle and the rack (see
illustration). If the fit is too tight, you may need
to loosen the screws on the back of the handle to
increase the gap.
The wine shelves are held securely by the anti-
vibration bumpers. If there is too much play side-to-
side, tighten the bumpers against the compartment
walls by rotating with your fingers.
GLASS SHELVING ADJUSTMENT
The glide out glass shelves are already attached to the
mounting bracket/glide assemblies.
To install the glass shelves insert mounting brackets
into pilasters.
To remove the glass shelves, simply lift straight up
then pull the brackets out of the pilasters.