User Manual


For pedals with high milliamp draws such as Strymon, please utilize outputs
1 or 2 that can produce 500mA each.
 Eventide pedals such as the Time Factor and H9 may be powered by
outputs 1 or 2 with the addition of the CL6 converter, for proper DC jack tip
size and polarity.
 Line 6 M5 may be powered by outputs 1 or 2.
 Line 6 M9, and the modeling pedals (DL-4/MM-4), may be powered by
outputs 1 or 2, and will also require the CL6 converter.
 Line 6 Tone Core pedals may be powered by any 9Vdc output.
 Line 6 POD or M13 cannot be powered by the 1 SPOT Pro CS6.
 If more 9Vdc pedals need to be powered, a MC5 daisy chain (sold
separately) may be plugged into any of the 9Vdc outputs depending on mA
draw. For adding one more pedal, use the included MC2 cable.
 Pedals that do not utilize a power jack, yet are powered normally by a 9V
battery, may utilize any 9Vdc output, along with the CBAT converter.
 TC Electronic Nova pedals may be powered by outputs 5-6 in the 12Vdc
position.
 TC Electronic Classic and Tone Print series may be powered by any 9Vdc
output.
 Digitech Whammy: Versions 1-4 cannot be powered by the 1 SPOT Pro
CS6. Version 5 or Whammy DT may be powered by outputs 1 or 2.
 Radial Tonebone 15Vdc pedals can be powered by an 18Vdc output, using
the Reverse Polarity Converter (CYR) included with the 1 SPOT Pro.
Warranty:
The 1 SPOT Pro CS6 carries a 5-year warranty to the original owner, covering
faulty materials and workmanship.
The warranty is considered void for any of the following reasons:
1. The unit has been modified in any way.
2. Any repair has been attempted by anyone other than the manufacturer.
If your unit becomes defective during the warranty period, please contact
Truetone to obtain a return authorization. All contact information can be found
at Truetone.com
WARNING: Operation contrary to the guidelines set forth in this manual may
damage your pedals. Truetone is not responsible for the damage of your
pedals by improper usage.
Input Power Cable:
Your 1 SPOT Pro includes an input power cable. Insert the universal IEC plug
into the socket on the back of the 1 SPOT pro. Plug the other end into a wall
outlet or power strip.
FCC Notice:
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Truetone could void the user's authority to
operate the equipment.
- 2 - - 5 -
Environmental Protection
The trash can symbol indicates that waste electrical products
should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local authority
or retailer for recycling advice.