Truma Combi D 6 AU Operating instructions To be kept in the vehicle! Page 2
Truma Combi D 6 AU 2 1 11 6 13 16 10 4 5 12 8 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 9 3 7 A 14 15 B Fig. 1 Trademark information Truma Combi, referred to as Combi below. Table of contents Symbols used ......................................................................... Intended use .......................................................................... Safety instructions ............................................................. Function description ..............................
Safety instructions In the event of a leak in the heater, fuel supply or the exhaust duct: – switch off heater, – open windows and door, – ask an expert to inspect the entire system! Ensuring a safe operating environment – The unit may be operated only with appropriate Truma control panels and accessories. – Danger of suffocation! To ensure dissipation of exhaust gases, operate the device outdoors only. Never use in enclosed spaces or tents or breathe in the exhaust gases.
– The installer or vehicle owner must apply the yellow sticker with the warning information, which is enclosed with the appliance, to a place in the vehicle where it is clearly visible to all users (e.g. on the wardrobe door)! Ask Dometic Service to send you stickers, if necessary. – The system must comply with the respective regulations of the country in which it is used. National regulations and rules must be followed.
Function description The Combi diesel heater is a warm-air heater with integrated hot water system (10 litre volume). The burner is fan-assisted, which ensures that operation is problem-free, even when on the move. In heating and hot water mode the heater can be used to heat the room and heat water up at the same time. If only hot water is required, select hot water mode. –– In hot water mode, the water is heated at the lowest burner setting.
Drain valve Draining the hot water system The drain valve automatically equalises the pressure in the event of overpressure in the system. When this occurs, the water is drained to the outside in intermittent bursts via a drainage socket. –– Switch off the power for the water pump (either by the main switch or the pump switch). This drain valve does not protect the water container from frost damage. c b a Fig.
Maintenance Technical data Only original Truma parts may be used for maintenance and repair work. –– Even outside the season, the heater should be operated once a month for about ten minutes. –– Clean installation area at least once per year, and have unit checked for soiling and cleaned by an expert if necessary. –– The drain valve must be actuated regularly (at least twice per year) in order to remove limescale deposits and to ensure that it is not blocked.
Faults Accessories Faults – Heater Descriptions of possible fault causes and a troubleshooting guide can be found in the operating instructions for the control panel that is installed. Faults – Water supply Possible fault causes and a troubleshooting guide – See “Troubleshooting guide (water supply)”. Troubleshooting guide (water supply) Fault Cause / Rectification Water taking an extremely long time to heat up. Water container furred. / Descale water system (see maintenance).
Truma warranty policy The warranty is given by Leisure-Tec Australia Pty. Ltd., 50 Metrolink Circuit, Campbellfield, Victoria, 3061, Australia for 12 months from the date of purchase against any defect arising from faulty materials or workmanship. Repairs will be carried out during normal business hours only by Leisure-Tec Australia Pty. Ltd., or its duly authorised service agents, and are subject to the warranty conditions and exclusions hereunder.
Notes
Notes
In Australia, always notify the Leisure-Tec Service Centre if problems are encountered; in other countries the relevant service partners should be contacted (www.truma.com). 34020-00303 · 02 · 05/2018 · © Having the equipment model and the serial number ready (see type plate) will speed up processing. Leisure-Tec Pty. Ltd. 50 Metrolink Circuit Campbellfield, VIC 3061 Australia Service (Australia) Telephone: +61 1300 07 2018 E-Mail: service@leisure-tec.com.
