Assembly Instructions

bend radius of the cable (Rmin = 80 mm) may not be fallen
short of if the focusing optics is subjected to dynamic move-
ments. The plug-in length is 9 mm.
Connector (2) comes from the protective glass monitoring unit or
another electrical component on the focusing optics and must
be able to be manually inserted into/removed from the built-in
socket (4) of the interface module. Here, the permissible bend
radius of the cable (Rmin = 80 mm) may not be fallen short of.
The plug-in length is 6 mm.
1 Cover 2 Fixing screws 3 Clamping screws
Connecting cable on protective glass monitoring module Fig. 2-34
When laying the connecting cable of the protective glass moni-
toring unit, the cover (1) and the fastening screws (2) can be
removed. Afterwards, the clamping screws (3) can be slightly
loosened and the angular position of the cable can be adjusted.
Once the cable is in the desired position, the clamping screws
(3) are tightened again. Afterwards, the cover (1) is remounted
with the fastening screws (2).
2‐38
Installation
2020-01 22-50-17-CRen
Connecting cable of the
protective glass monitoring
unit